Search found 150 matches

by Cozz
Sun Jun 12, 2005 7:52 pm
Forum: General Discussion & Intro Forum
Topic: Another pic of Ztee
Replies: 42
Views: 10123

Can someone plase tell me WTF is going on? How do we go from a pic to crack to stalkers? Should I even bother to try and put this all together?
by Cozz
Fri Jun 03, 2005 10:11 pm
Forum: General Discussion & Intro Forum
Topic: Boring!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Replies: 9
Views: 3660

AlexD wrote:Na man. Did not find 1 yet

A second baby :shock: You're going to make a cozz army. :lol:
I need more hands to hold tools damn it!!! :mrgreen:
by Cozz
Fri Jun 03, 2005 9:58 pm
Forum: General Discussion & Intro Forum
Topic: Boring!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Replies: 9
Views: 3660

Sorry, too busy to hang around here. Working on a 68 Firebird soft top.... for the next 2 years. Working on the 911 motor. Fixing the house, thinking of a second baby.

Alax, you found a job yet? :D I wish I had time like you.
by Cozz
Thu May 26, 2005 8:02 am
Forum: XR4Ti
Topic: low to high impedance
Replies: 6
Views: 2007

svo855 is correct. Low impedence drivers will hold low and high. You can also go ballast resistors but that's another deal all together. ahhh... those Wolf 3D's back in the days.
by Cozz
Tue May 24, 2005 8:37 pm
Forum: XR4Ti
Topic: dipstick? *UPDATE WITH PIC*
Replies: 30
Views: 9062

Crap, I just threw out a dip stick and holder yesterday. I was thinking who would ever need one. :(
by Cozz
Wed May 18, 2005 7:28 pm
Forum: XR4Ti
Topic: Power antenna drain hose?
Replies: 8
Views: 3565

Most older cars had them in the rear. They all had tubes that went no where.
by Cozz
Wed May 18, 2005 7:58 am
Forum: XR4Ti
Topic: Engine Volumetric Efficiency
Replies: 19
Views: 5366

Stock 2.3 VE= about .75-.80 without boost. That high??? I've always thought that our engines flowed less than most stockers. :? For what I remember some years back. I did a calculation by using the stock VAM voltage numbers vs. air flow at a certain rpm. Subtract that to the size of the motor (100%...
by Cozz
Tue May 17, 2005 11:36 pm
Forum: XR4Ti
Topic: Power antenna drain hose?
Replies: 8
Views: 3565

The drain hose doesn't really drain much of anything. It's just incase any water goes inside the motor from the metal shaft. If there is enough water buildup then can reach the motor inside. You'll be lucky to see an once per year out of that hose.
by Cozz
Tue May 17, 2005 11:10 pm
Forum: XR4Ti
Topic: Engine Volumetric Efficiency
Replies: 19
Views: 5366

Stock 2.3 VE= about .75-.80 without boost.
by Cozz
Sun May 15, 2005 10:01 pm
Forum: General Discussion & Intro Forum
Topic: Simpsons Episode with Merkurs?!?
Replies: 30
Views: 9109

I gues it's the second or third episode where Skinner and Merkur are mentioned.

pretty cool
by Cozz
Sun May 15, 2005 9:57 pm
Forum: XR4Ti
Topic: Head Gasket Replacement
Replies: 30
Views: 6172

The car should run ruff at idle and revving. But it shouldn't make any metal noises like a spun bearing or shot valve. It will also ping under boost. Check the compression. Unplug the sparkplug wire with the lowest compression. It should make little difference. If it gets even worse then it might be...
by Cozz
Sun May 15, 2005 9:53 pm
Forum: XR4Ti
Topic: Fuel pump questions
Replies: 1
Views: 1243

Normally people just drop the inline and bypass the secondary pump.

The factory stuff in known to hold over 300HP.

You can get the mustang tank kit.
by Cozz
Sun May 15, 2005 2:31 pm
Forum: XR4Ti
Topic: Head Gasket Replacement
Replies: 30
Views: 6172

A headgasket is straight forward but a little time consuming if being done the first time. It's pretty cheap. You need an intake gasket kit, head gasket and valve cover gasket.

Be careful and make sure that it's the head gasket and not a piston or head problem.
by Cozz
Fri May 13, 2005 6:52 pm
Forum: General Discussion & Intro Forum
Topic: I lost to a SRT-4!!
Replies: 52
Views: 13884

Hey Mo at least you're not driving a Neon (SRT-4 or not). :wink: I don't care how fast they are...no thanks, still a Neon. I'd take your "slow" Cossie any day. :lol: Funny, I thought the same thing until I worked on one. The thing is beuitiful inside. The seats are perfet for racing yet n...
by Cozz
Wed May 11, 2005 8:20 am
Forum: XR4Ti
Topic: Do I have a N/A engine?!
Replies: 25
Views: 6015

Block- Does it have the tap for the oil return from the turbo? It goes under the turbo to the block. A NA block doesn't have the tap for it. You would need to tap the oil pan

Head- The outer intake ports look like upside down "D"s