The Merkur Club of America Forums

So, the blower does not come on at all? It's and easier fix if it blows only one speed (as in on high).

Try the gray stuff, it's delicious.
(It also is RTV, Boys).

Take off the rear plate, no gasket is required. Use a thin shmeer of RTV to insure a good seal. Don't forget to reinstall the top vent.

Does this look like the same one?
http://www.ebay.com/itm/111343336861?_t ... EBIDX%3AIT

BTW, I called BAT, seals out of stock. O rings, one left
Rapido, $28+ for each seal, $14 for an O ring.

Hello, my name is Mark and I am a Dumbass. I went out determined I was not using my head. Got back under the car. Turned the driveshaft, C clips. For my next trick, I will gargle peanut butter. I have the stub frames & carriers out. The seals are in the tight. They had to be destroyed beyond rec...

Can you price me the proper seals?

As far as I can tell, the Ford part for the rear diff grease seal # is E5RY1190A
That translated to the Timken part # 3743

Luck I had for once. Got all of the bolts out without any problems. I think the diff is leaking so bad, it lubed the bolts.

Not having much luck locating the differential seals.

Is there a trick to removing the rear axles without breaking 14 torx bits?

Pre-soak and then heat?

I am in Chillicothe every now & then on my job.
At that moment I saw your car, I was stopping in at Casa Del Taco. Om nom nom...

Today, driving down Bridge Street.
Anyone here?

Anyone spot the silver 88-89 XR4Ti in the parking lot during the 3/29/10 episode titled "Bumpy Ride"? It was right next to the rickshaw that was attempted to be pawned.

I bet you it's the fader. You might need to bypass it.

This is from an email from Rodd, the show promotor. Hello, The 9th Annual All German Car Show is here! Sponsored by Germain Mercedes-Benz of Columbus (www.easton.mercedesdealer.com). Hosted by the Central Ohio Section of the MBCA (www.mbca.org). Benefits Pilot Dogs, Inc. (http://sites.google.com/sit...