Need to source these fittings

General discussion relating to club happenings and items related to Merkurs in general such as "Merkur sightings". If you just signed on, please feel to start a new thread and introduce yourself here. Posts specifically regarding either the XR4Ti or Scorpio should go in those specific forums. Feel free to make suggestions on improving this forum here as well.
Post Reply
Merkur Club web site
usmcgunner27
Level 3
Level 3
Posts: 201
Joined: Fri Feb 25, 2011 11:54 am
Location: Beaufort, South Carolina
Contact:
Contact usmcgunner27

Need to source these fittings

Post by usmcgunner27 »

Anyone know where these fittings can be found? I need them, and I'm sure anyone that gets biggrgivens fuel rail, and FPR block will need these same things.
I know, its a terrible pic, but here it is:

Image
red 88 XR WORKED, inside and out. BEFORE: 225 HP 304 Lb/Ft Torque; After is to come
1989 Scorpio, Eurofied.....Eurospec V-6 in her future???
Top
itking
Level 4
Level 4
Posts: 356
Joined: Sun Jul 28, 2013 6:32 pm
Location: Menomonee Falls, WI

Re: Need to source these fittings

Post by itking »

I've seen these type of fitting on the following websites.

http://www.jegs.com/

http://www.summitracing.com/

I've used both places when I redid my all my brake & tranny lines on my Dodge Ram.
Ron
1989 Merkur XR4Ti - Magenta [My XR]
1988 Merkur XR4Ti - Bunny [Wife's XR]
1988 Merkur XR4Ti - Raven [Daughter's XR]
1985 Merkur XR4Ti - Wombat [Youngest Son's XR]
1997 Dodge Ram 1500 4x4 5.9L - Betsy
2002 Buick Century Custom - Daily Driver
1968 Dodge Charger 383
Top
Post Reply

Return to “General Discussion & Intro Forum”