U-Joint Demo at Carlisle
-
- Level 7
- Posts: 1528
- Joined: Sat Feb 08, 2003 10:11 am
- Location: Phila, PA.
U-Joint Demo at Carlisle
I will bring the used and new Merkur Depot U-joints and flange to the tent on Saturday if anyone wants to see them. They fixed my noise and vibe problem. Mike, I would bring some extra's with you, you might be selling a few to get rid of the hard spot and slop in the driveshaft. See you all there.
German engineer: We custom fit every part in the Porsche engine.
Japanese engineer: You mean that you make every part wrong to begin with?
Japanese engineer: You mean that you make every part wrong to begin with?
- merkurdriver
- Level 8
- Posts: 6366
- Joined: Tue Jan 21, 2003 4:29 pm
- Location: Northeast Ohio
- Contact:
Re: U-Joint Demo at Carlisle
Thanks for doing the demo.
Might encourage others to do the replacement.
Might encourage others to do the replacement.
- DPDISXR4Ti
- Site Admin
- Posts: 14826
- Joined: Wed Jan 08, 2003 11:40 pm
- Location: New York
-
- Level 7
- Posts: 1528
- Joined: Sat Feb 08, 2003 10:11 am
- Location: Phila, PA.
Re: U-Joint Demo at Carlisle
Sounds good to me Brad. See you then.
German engineer: We custom fit every part in the Porsche engine.
Japanese engineer: You mean that you make every part wrong to begin with?
Japanese engineer: You mean that you make every part wrong to begin with?
Re: U-Joint Demo at Carlisle
This sounds like a great demo that definitely adds value to the Carlisle trip!
- DPDISXR4Ti
- Site Admin
- Posts: 14826
- Joined: Wed Jan 08, 2003 11:40 pm
- Location: New York
Re: U-Joint Demo at Carlisle
In addition to the U-joint demo, I'll add two quick things to the agenda after Don...
1) Why do timing belts "mysteriously" mis-track, even though I've replaced the tensioner?
2) When good wiring harnesses go bad (and what to do about it).
Answers provided and samples displayed!
1) Why do timing belts "mysteriously" mis-track, even though I've replaced the tensioner?
2) When good wiring harnesses go bad (and what to do about it).
Answers provided and samples displayed!
Brad
-
- Level 7
- Posts: 1528
- Joined: Sat Feb 08, 2003 10:11 am
- Location: Phila, PA.
Re: U-Joint Demo at Carlisle
As an added surprise, I just found out that I will be bringing a truly needed, newly designed, custom made part that everyone will want after they see it.
German engineer: We custom fit every part in the Porsche engine.
Japanese engineer: You mean that you make every part wrong to begin with?
Japanese engineer: You mean that you make every part wrong to begin with?