Help me

[brokencase]

Vovan, just a little info about the wires that run along the frame on that side of the car.

a) Connection to the EGR pressure sensor. This sensor clips to the air filter.
b) A/C clutch wiring - there is the a/c clutch diode along the frame. Connections often go bad on this diode. Best to solder in a new diode.
c) Vacuum switch for transmission converter lockup solenoid. Test this vacuum switch to ensure it trips at 15 inches of vacuum.
Some people replace this with a switch on the dash and turn on lockup only when on the highway.
d) Ignition coil. Make sure connections are clean.
e) ABS front wheel sensor comes in here also.

Download this if you do not have it:
https://www.mediafire.com/file/6hpsypcn ... p.pdf/file

[Vovan]

Vovon, just a little info about the wires that run along the frame on that side of the car.

a) Connection to the EGR pressure sensor. This sensor clips to the air filter.
b) A/C clutch wiring - there is the a/c clutch diode along the frame. Connections often go bad on this diode. Best to solder in a new diode.
c) Vacuum switch for transmission converter lockup solenoid. Test this vacuum switch to ensure it trips at 15 inches of vacuum.
Some people replace this with a switch on the dash and turn on lockup only when on the highway.
d) Ignition coil. Make sure connections are clean.
e) ABS front wheel sensor comes in here also.

Download this if you do not have it:
https://www.mediafire.com/file/6hpsypcn ... p.pdf/file

this is useful information

[brokencase]

Yes, the important thing is the EVTM will tell you where things are located.

[Vovan]

Yes, the important thing is the EVTM will tell you where things are located.

A very detailed book, I have never seen anything like it before. It will be convenient to use it to assemble a car.

[Vovan]

Vovan - the routing of the vacuum lines is a little complicated. If you need details on this just let us know. I can take more closeup pictures as needed. My engine bay area is pretty original.

Can you send me a photo of how the headlights are attached? If possible

[brokencase]

Vovan - I converted to Euro spec headlamps, and I had to make modification to do this. So I'm not sure pictures of my setup would help you.
The two headlamps styles are a bit different. I'll take some pictures from behind the grill anyway.

Maybe someone else can take some photos of the US style.

[Ed Lijewski]

Vovan should buy the Scorpio Service Manual. It's well worth whatever total cost (price paid plus shipping).

YMMV

[Vovan]

Hi everyone! When I was disassembling the car, I remember that there was a grille in this place, but I don't remember how it is attached or what it looks like. If someone can take a picture of this place, I would be grateful.

[my8950]

Hi everyone! When I was disassembling the car, I remember that there was a grille in this place, but I don't remember how it is attached or what it looks like. If someone can take a picture of this place, I would be grateful.

Image does not show up, at least for me. ???

[Vovan]

Hi everyone! When I was disassembling the car, I remember that there was a grille in this place, but I don't remember how it is attached or what it looks like. If someone can take a picture of this place, I would be grateful.

Image does not show up, at least for me. ???

I see this image. I don't know what to do to fix it(

[MarkM]

I didn't have any problem viewing the image, but I will try to attach it to this post for those who do have issues.

Scorpio20241105.jpg (731.7 KiB) Viewed 1427 times

[my8950]

Screenshot...

[MarkM]

I didn't doubt that it wasn't showing up for you. I've had similar things happen in the past, both here and on other forums, where others could see an image and I saw nothing. However, troubleshooting these issues can be very difficult, because of the many variables involved between the different clients. From operating system, browser, configuration, security settings, plug-ins, the list just goes on and on.

Far simpler to take the image that I could view and attach it to my post where (almost) everyone should be able to view it and move on with trying to answer the original question.

[brokencase]

Vovan - There are several layers of things that go in that area. Blower assembly, heat shields, etc...

I found the following images in my library that might help.
.
.

Engineintakeremoved.jpg (242.76 KiB) Viewed 1370 times

.
.

101_6105-1.jpg (83.71 KiB) Viewed 1370 times

.
.

100_7468-1.jpg (85.83 KiB) Viewed 1370 times

[Vovan]

Vovan - There are several layers of things that go in that area. Blower assembly, heat shields, etc...

I found the following images in my library that might help.
.
.
Engineintakeremoved.jpg
.
.
101_6105-1.jpg
.
.
100_7468-1.jpg

Oh, there really is a mesh. Thank you very much for the photo.
P.S. It's disgusting to saw the fan housing. I thought only Russia did that. By the way, I'll soon post a report on working with this box, now I'll have an air filter for the interior.